INSTALLATION INSTRUCTION - INSTRUCCIONES DE INSTALACIÓN FOR CLAD AWNING, CASEMENT & NON-RECTANGULAR CASEMENT WINDOWPARA LAS VENTANAS DE MADERA RE

INTERIOR FINISHINGIf products cannot be nished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any constructi

INSTALLING ROTO COVER AND CRANKNote: Finish the interior of the window and allow the window to dry before proceeding with these instructions. (To open

YOU WILL NEED TO SUPPLY: TOOLS REQUIRED:• Cedar or Impervious shims/spacers (12 to 20)• 2" galvanized roong nails (1/4 lb.)• Closed cell foam ba

E. Apply sill ashing tape #1. Cut a piece of ashing tape 12" longer than the opening width. Apply at the bottom of the opening as shown (1E) s

Interior 2F2FF. Plumb and square window. Place shims 1" from the bottom and top of the window between the window and the sides of the opening. A

12 0 3 0 4 0 5 0 6 0 7 02 3INCHESmm2G2IG. Check the interior reveal. Make sure the measurement from the interior face of the window to the interior fa

3D3C3DC. Fold down top ap of water resistive barrier (3C).D. Apply ashing tape to diagonal cuts. Cut pieces of ashing tape at least 1" longer

Exterior 3C3C3B3INTEGRATING THE WINDOW TO THE WATER RESISTIVE BARRIER (continued)Curve Top and Angle Top Units Only:A. Units that do not have pre-ap

Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’s recommendations for appl

A. Insert backer rod into the space around the window approximately 3/8" deep. is should provide at least a 3/8" clearance between the bac