Pella 81AK0101 Manuel d'utilisateur

INSTALLATION INSTRUCTION - NAIL FIN INSTALLATION AFTER WEATHER BARRIER ANDFRAME SCREW OR CLIP INSTALLATION FOR REPLACEMENT ALUMINUM-CLAD EXTERIOR HIN

4INTEGRATING THE DOOR TO THE WATER RESISTIVE BARRIER (continued):B. Apply top flashing tape. Cut a piece of flashing tape long enough to go across the

5DOOR REPLACEMENT IN SIDING WITHOUT NAIL FIN (continued):D. Clean the vinyl j-channel/trim and rough opening with isopropyl alcohol or window cleane

5DOOR REPLACEMENT IN SIDING WITHOUT NAIL FIN (continued):Fastening Door to OpeningI. After setting the door plumb level & square, secure the doo

Installation Clip Method:See Step 2C for Clip Application DetailsP. Fasten the door to the opening by driving two #8 x 1-1/4" corrosion resistan

6INTERIOR SEAL:Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’s recommend

7SEALING THE DOOR TO THE EXTERIOR WALL CLADDINGWhen applying siding, brick veneer or other exterior finish material, leave adequate space between the

INTERIOR FINISHINGIf products cannot be finished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any constructi

EXTERIOR FINISHINGThe exterior frame and sash are protected by aluminum cladding with a Pella EnduraClad® or EnduraClad Plus baked-on factory finish th

TROUBLESHOOTING - Adjustable Strike Latching IssuesTABSAdjustable strike shim(side view)Strike(front view)Adj. Strike Shim(end view)Factory installed

The performance of any building is dependent upon the design, installation, and workmanship of the entire building system. Pella Corporation strongl

FOR DOORS USING OPTIONAL SILL PAN GO TO STEP 1I. Exterior1D4th cut: Make a 6" cut up from each top corner at a 45o angle to allow the water resis

Optional Sill Pan Instructions:I. Cut the sill pan to the width of the rough opening plus 2".Note: The 2" added onto the rough opening widt

2PREPARE THE DOOR FOR INSTALLATION:TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL AND FRAME SAFELY.A. Remove plastic wrap and cardboard pack

3SETTING AND FASTENING THE DOOR:A. Place three 3/8" beads of sealant. Place the first beads sealant 1/2" in front of the base of the interio

G. Fasten the door to opening by driving 1-1/2” galvanized roong nail into each pre-punched hole in the nailing fin.Note: Make sure the fin corner is

K. Double Doors Only: Designer Series®: Place a dab of sealant into the center sill strike hole and install the #8 x 3" at head corrosion resi

Note: Do not adjust the hinge with the top and bottom screws loose; this could force the hinge to adjust beyond its design capability which can cause