Pella 81470102 Manuel d'utilisateur

INSTALLATION INSTRUCTION - INSTRUCCIONES DE INSTALACIÓN FOR SQUARE DESIGN BAY AND BOW WINDOW WITH SEAT BOARD Part Number: 81470102© 2009 Pella Corpo

A. Install wood blocking between the top of the window and the sot as shown. e blocking should be ush with the exterior of the window frame.B. Ap

L. Insert backer rod and apply sealant. Install siding, and insert backer rod between the each jamb cover and the exterior nish material as deep as

INTERIOR FINISHINGIf products cannot be nished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any constructi

A. Remove all packaging from the window.B. REPLACEMENT APPLICATIONS: Remove the existing, window, trim, insulation and sealant from the opening.1ROU

1ROUGH OPENING PREPARATION (CONTINUED)1" 1/2" 1/2" 6" 1H1IFlashing tape overhanging 1"to the exterior.6" 1HFlashing tape

2PREPARING AND SETTING THE WINDOWA. Install exterior jamb covers. Apply sealant along the leg of the jamb frame cover(s). Apply a bead of sealant to

B. Insert the window from the exterior of the building. Place the seat of the window at the bottom of the opening and slide the top into position. Ce

CROSS BRACING MOUNT OF CABLE CLAMPSA. Install 2" x 6" cross braces between rafter tails, directly above the cable holes in the bay/bow head

3 CABLE CLAMP INSTALLATION (CONTINUED)A. Tighten the top hex nut on both cable ends. Using a 3/16" wrench or socket, hold the cable end in posit

5INSULATING FOAM APPLICATIONCaution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufactur

Note: e sealant details shown are standard recommendations from the sealant industry. Contact your sealant supplier for recommendations and instructi